JMY505 series are RFID reader/writer module with UART and IIC serial ports. JMY505 has various functions and supports multi ISO/IEC standard of contactless card; the cards from different suppliers. The RF protocol is complex. But the designer combined some frequent used command of RF card and then user could operate the cards with full function by sending simple command to the module through IIC or UART interface. And the module and antenna are separate design. The impedance between RF module and antenna was tuned by impedance analyzer. And then the module has excellent performance and stability. The module and antenna is linked by 50ohm coaxial line. The performance is good, though the wire can reach 10m. Normally the wire should be 60cm that is the module's best performance and stability.



    Qualifications:

     Model Number:JMY505A,JMY505C,JMY505G,JMY505H

     PCD: MF RC500, RC531, RC632, RC400

     Working frequency: 13.56MHz

     Antenna connection: by 50ohm coaxial line, (recommend 60cm, Max. 10 meters), due to order

     RF standard: ISO14443A, ISO14443B, ISO15693

     Operating distance: 100mm(depending on card and antenna design)

     Anti collision ability: Full function anti collision; be able to process multi-cards simultaneously; be able to set operate single card only

     EEPROM: 512 Bytes

     Interface: IIC & UART (selected by SPS pin, recommend to use IIC)

     Communication rate: IIC--400Kbps, UART--19.2Kbps/115.2Kbps

     Max.command length: 511 Bytes

     Interface level: 3.3V(TTL level; 5V tolerance)

     Power supply: DC 5.0V

     Power consumption: 70mA

     Dimension: 42mm×21mm×8mm

     Package: DIP32

     Weight: about 15g

     Operating temperature: -25 ~ +85 ℃ (-77 ~ +185°F)

     Storage temperature: -40 ~ +125 ℃ (-104 ~ +257°F)

     ISP: Supported

     RoHS: Compliant